Install Snaps with a Pop Rivet Tool with The SnapRite Surface Mount Stud Die

Install Snaps with a Pop Rivet Tool with The SnapRite Surface Mount Stud Die

Order the SnapRite Surface Mount Stud Die from Sailrite:

SnapRite Surface Mount Stud Die is a uniquely designed die that screws into the end of a standard pop rivet tool to quickly install stud fasteners to a hard surface. The die holds the rivet and stud in place so parts are not loose or falling off during installation, and the installation results is a tight fitting stud!

The SnapRite Surface Mount Stud Die offers a better alternative to screw-in studs with a quicker installation process and a lower stud profile. Use to install studs to fiberglass, stainless steel or aluminum tubing, steal frame, galvanized pipe, and other hard materials that can be riveted. The SnapRite Surface Mount Stud Die is made in the USA and is Stainless Steel.

SnapRite Surface Mount Stud Die Instructions:
Screw die into pop rivet tool.
Insert blind pop rivet (see rivet specifications).
Press stud into place inside die.
Rivet stud to surface using pre-drilled 1/8″ hole.
Use with aluminum or stainless steel blind rivets (aka pop rivets or open end rivets). The length of the rivet must be able to accommodate the thickness of the surface.

Rivet Specifications:
Domed head
Maximum head diameter: 0.262 inch
Head height: 0.04 inch
Most common length: 0.462 inch (for 0.05–0.29″ thickness)
Minimum length: 0.33 inch (for 0.05–0.125″ thickness)

Order the SnapRite Surface Mount Stud Die from Sailrite: e